3 November 2016 - Brake system

• Connected the front and rear brake system lines to the master cylinder
• started bleeding the front brake system, did not have time to do the rear brake system today.

 Todo;

• install driver and passenger side tie rod assemblies
• install idler arm
• install coil springs - driver & passenger side
• install coil spring covers- driver & passenger side
• Grease all suspension points/ball joints
• install front sway bar - partially installed, will finish when full weight is on suspension
• install wheel/tires(tire shop has both front rims and will install new tires by 1 Nov 2016.  Tires are Cooper Cobra 235/60r14.
• on the driver side, tighten lower control arm eccentric eliminator bolt(do not torque until engine/transmission is installed)
• on the passenger side, loosen but make sure its tight, the lower control arm eccentric eliminator bolt.
• lower vehicle - all four wheels on the ground
• install brake power booster/master cylinder assembly 
• install front driver side and front passenger side brake flex hoses
• manually adjust front drum brakes
• install power booster
• install master cylinder
• bleed brake system 
• try to do some kind of front end alignment so car is driveable...